Benchtop mill for ointments

Pharmaceutical and cosmetic creams, ointments, gels and pastes can deliver a wide range of active ingredients. Particle size is a key factor in determining the effectiveness of the emulsion in delivering maximum skin absorption of the ingredients. For high-quality, small batch ointment production, a dedicated, easy-to-use, yet low-cost mill is the ideal solution for achieving optimum particle size.

Easy to use triple roller mill for ointments and creams

The MPC Ointment Mill from Multigel is a small form-factor mill for fine trituration and homogenization of ointments, creams, pastes, gels and suspensions.

This mill has been designed specifically to reduce the particle size for increased product quality through better absorption into the skin.

The MPC has three specially-designed ceramic rollers made from aluminium oxide (Al2O3 99.7%). These provide fine trituration while being extremely easy to clean with non-abrasive detergent and alcohol.

To assist with compound placement and reduce wastage, two side guides are fitted on top of the rollers. Once passed through the rollers, the compound is removed by a scraper plate and falls down a collection chute. Multiple compound runs are possible until the desired level of trituration has been achieved.


  • Small, lightweight ointment mill for fine trituration of small batches
  • Ceramic rollers for quick and simple cleaning
  • Easy to adjust rollers offer repeatable accuracy of trituration
  • Benchtop form factor and single-phase electrical supply for easy installation